DS3 vs Multiple T1 Lines
Bonding T1 lines for greater bandwidth is a good value up to about
8x or 9x bonding. Above that, it makes better economic sense to
order DS3 service over fiber or T3 copper line. In metropolitan
areas with high levels of buildout, the decision point may be
less than 8 T1 lines.
When to Use Pseudowires
A pseudowire is a virtual "circuit" that emulates a
traditional digital telecom service but on a packet switched network.
MPLS networks are especially suitable for pseudowires. By using
a pseudowire circuit, you can get the point to point connectivity
you desire without having to re-engineer your facilities to accommodate
a different protocol network.
DS3 for Call Center Telephony
DS3 voice service can support up to 672 simultaneous telephone
conversations without blocking. If your call center or large corporate
PBX system requires this number of outside lines, DS3 is likely
far more cost effective than ordering the equivalent 28 T1 lines.
DS3 as Ethernet Transport
DS3 bandwidth at 45 Mbps can easily transport 10 Mbps Ethernet
over SONET or T3 line, even with the additional overhead needed
to convert from packet to TDM back to packet protocol. For Fast
Ethernet transport, an OC3 service at 155 Mbps would be required.
Difference Between DSL and
DSL means Digital Subscriber Line and is a shared bandwidth service
offered on a "best effort" basis by telephone companies.
DS3 is a professional telecom service with a fixed bandwidth of
45 Mbps both upload and download. DS3 is usually sold with on
a contract with a service level agreement.