DS3 vs Multiple T1 Lines
Bonding T1 lines for greater bandwidth is a good value up to about
8x or 9x bonding. Above that, it makes better economic sense to
order DS3 service over fiber or T3 copper line. In metropolitan
areas with high levels of buildout, the decision point may be
less than 8 T1 lines.
When to Use Pseudowires
A pseudowire is a virtual "circuit" that emulates a
traditional digital telecom service but on a packet switched network.
MPLS networks are especially suitable for pseudowires. By using
a pseudowire circuit, you can get the point to point connectivity
you desire without having to re-engineer your facilities to accommodate
a different protocol network.
Applications Demanding DS3
DS3 transport is often used for real time video transport, high
resolution images, large engineering files, and data backups to
remote data centers. You can get this bandwidth through fiber
optic delivery or over copper coaxial lines, called T3 lines.
DS3 as Ethernet Transport
DS3 bandwidth at 45 Mbps can easily transport 10 Mbps Ethernet
over SONET or T3 line, even with the additional overhead needed
to convert from packet to TDM back to packet protocol. For Fast
Ethernet transport, an OC3 service at 155 Mbps would be required.
What is DS3 over Copper?
DS3oC, or DS3 over Copper, is a last mile connectivity solution
that delivers high bandwidth service where fiber optic connections
are unavailable or not cost effective to construct. Instead, standard
twisted pair copper wires like those used for telephone or T1
line service provide the link from the carrier POP to your building.
Multiple pairs and special modulation schemes are used to provision
carrier-grade DS3 service on copper wiring.