DS3 vs Multiple T1 Lines
Bonding T1 lines for greater bandwidth is a good value up to about
8x or 9x bonding. Above that, it makes better economic sense to
order DS3 service over fiber or T3 copper line. In metropolitan
areas with high levels of buildout, the decision point may be
less than 8 T1 lines.
When to Use Pseudowires
A pseudowire is a virtual "circuit" that emulates a
traditional digital telecom service but on a packet switched network.
MPLS networks are especially suitable for pseudowires. By using
a pseudowire circuit, you can get the point to point connectivity
you desire without having to re-engineer your facilities to accommodate
a different protocol network.
DS3 as an Internet Backbone
DS3 service configured as an dedicated Internet port offers 45
Mbps of upload and download bandwidth. This is ideal for small
and medium size ISPs and WISPs. that have exceeded the capacity
available from multiple T1 lines.
How Does DS3 differ from T3?
The terms DS3 and T3 are often used interchangeably. Both refer
to a TDM (Time Division Multiplexing) digital telecom service
operating at 45 Mbps. Strictly speaking, DS3 is the digital signal
level that can be carried by either copper or fiber physical links.
T3 is the T-Carrier standard for DS3 over coaxial copper service.
What is DS3 over Copper?
DS3oC, or DS3 over Copper, is a last mile connectivity solution
that delivers high bandwidth service where fiber optic connections
are unavailable or not cost effective to construct. Instead, standard
twisted pair copper wires like those used for telephone or T1
line service provide the link from the carrier POP to your building.
Multiple pairs and special modulation schemes are used to provision
carrier-grade DS3 service on copper wiring.