DS3 vs Multiple T1 Lines
Bonding T1 lines for greater bandwidth is a good value up to about
8x or 9x bonding. Above that, it makes better economic sense to
order DS3 service over fiber or T3 copper line. In metropolitan
areas with high levels of buildout, the decision point may be
less than 8 T1 lines.
When to Use Pseudowires
A pseudowire is a virtual "circuit" that emulates a
traditional digital telecom service but on a packet switched network.
MPLS networks are especially suitable for pseudowires. By using
a pseudowire circuit, you can get the point to point connectivity
you desire without having to re-engineer your facilities to accommodate
a different protocol network.
DS3 for Call Center Telephony
DS3 voice service can support up to 672 simultaneous telephone
conversations without blocking. If your call center or large corporate
PBX system requires this number of outside lines, DS3 is likely
far more cost effective than ordering the equivalent 28 T1 lines.
What is the T-Carrier System?
T-Carrier is a set of standards developed by the Bell Telephone
Companies back in the 1950s. These include T1 and T3 lines. They
also define digital signal levels such as DS0, DS1 and DS3. DS0
is 64 Kbps, DS1 is 1.5 Mbps and DS3 is 45 Mbps.
The Importance of DS0
DS0 and DS3 are part of the same set of digital signal standards.
DS0 is 64 Kbps, the bandwidth required to support one telephone
call of 8 bits at a sampling rate of 8 Kbps. DS3 has a speed
of 44,736 Kbps, commonly referred to as 45 Mbps. This speed level
was chosen so that 672 DS0s could be multiplexed into one DS3.
One DS3 can also multiplex 28 DS1 services. DS1 is the signal
level transmitted on a T1 line.