DS3 vs Multiple T1 Lines
Bonding T1 lines for greater bandwidth is a good value up to about
8x or 9x bonding. Above that, it makes better economic sense to
order DS3 service over fiber or T3 copper line. In metropolitan
areas with high levels of buildout, the decision point may be
less than 8 T1 lines.
When to Use Pseudowires
A pseudowire is a virtual "circuit" that emulates a
traditional digital telecom service but on a packet switched network.
MPLS networks are especially suitable for pseudowires. By using
a pseudowire circuit, you can get the point to point connectivity
you desire without having to re-engineer your facilities to accommodate
a different protocol network.
Applications Demanding DS3
Bandwidth
DS3 transport is often used for real time video transport, high
resolution images, large engineering files, and data backups to
remote data centers. You can get this bandwidth through fiber
optic delivery or over copper coaxial lines, called T3 lines.
How Does DS3 differ from T3?
The terms DS3 and T3 are often used interchangeably. Both refer
to a TDM (Time Division Multiplexing) digital telecom service
operating at 45 Mbps. Strictly speaking, DS3 is the digital signal
level that can be carried by either copper or fiber physical links.
T3 is the T-Carrier standard for DS3 over coaxial copper service.
What is Fractional DS3 Service?
Fractional DS3, as the name implies, is a fraction of the full
DS3 bandwidth of 45 Mbps. Companies order fractional DS3 when
they don't need or want to pay for the full bandwidth offered
by DS3. Even with fractional DS3, you still need the full coaxial
or optical hardware support for 45 Mbps signaling. At low fractional
requirements, bonded T1 lines offer a more cost effective solution.