DS3 vs Multiple T1 Lines
Bonding T1 lines for greater bandwidth is a good value up to about
8x or 9x bonding. Above that, it makes better economic sense to
order DS3 service over fiber or T3 copper line. In metropolitan
areas with high levels of buildout, the decision point may be
less than 8 T1 lines.
WAN Bottlenecks Now Readily
Your Wide Area Network or WAN may be the bottleneck in your network
when you have significant voice or data transfer between facilities.
With lower line prices available, unclogging the WAN can cost
less than you think and can unleash higher business productivity.
DS3, OCx over SONET and Carrier Ethernet connections are recommended
for the corporate WAN.
Applications Demanding DS3
DS3 transport is often used for real time video transport, high
resolution images, large engineering files, and data backups to
remote data centers. You can get this bandwidth through fiber
optic delivery or over copper coaxial lines, called T3 lines.
DS3 as Ethernet Transport
DS3 bandwidth at 45 Mbps can easily transport 10 Mbps Ethernet
over SONET or T3 line, even with the additional overhead needed
to convert from packet to TDM back to packet protocol. For Fast
Ethernet transport, an OC3 service at 155 Mbps would be required.
The Importance of DS0
DS0 and DS3 are part of the same set of digital signal standards.
DS0 is 64 Kbps, the bandwidth required to support one telephone
call of 8 bits at a sampling rate of 8 Kbps. DS3 has a speed
of 44,736 Kbps, commonly referred to as 45 Mbps. This speed level
was chosen so that 672 DS0s could be multiplexed into one DS3.
One DS3 can also multiplex 28 DS1 services. DS1 is the signal
level transmitted on a T1 line.